JW Tuffwall

STEP 1. From the far left edge of your wall measure your 'J' length given above

STEP 2. Draw a pencil line using a plumbob or spirit level

STEP 3. Apply paste to reverse DROP A. Use a strong adhesive (such as Solvite Super Strength) and paste right to the edges. Take care not to miss any areas.

STEP 4. Line the left hand edge of DROP A to the line you have drawn. Use the faint positioning marks to line up the top of your drop to the top of your wall. Remember you have overlaps, do not trim them yet. Take time to make sure everything is smoothed properly into place and that all edges are stuck down.

STEP 5. Paste and position DROP B. Use the faint positioning marks on the edge of DROP A to position the left edge. Don't trim yet! Take special care to make sure there is plenty of paste on your overlaps.

STEP 6. Repeat the process.

STEP 7. Place each drop in order (you will have overlaps all around).

STEP 8a. Trim! Use a very sharp knife and your smoother to guide you, push into the corners and out slowly.

STEP 8b. Trim! Use a very sharp knife and your smoother to guide you, push into the corners and out slowly.

STEP 9a. Splice your sections. Make a clean, straight, vertical cut through BOTH layers at the centre of the overlaps

STEP 9b. Peel away the waste on the top layer

STEP 9c. Lift the overlap and peel away the waste on the bottom layer. Smooth both layers back down.

STEP 10. All done! Enjoy the results!