JW Easystick

STEP 1. From the far left of your wall measure your 'J' length

STEP 2. Draw a straight line using a spirit level or plumb line

STEP 3. Using some white tape, position Drop A exactly in place. Use the faint line at the top of the sheet to line up the top of the wall. Fit the left hand side to the line you have drawn.

STEP 4. Once you are lined up (make sure your tapes stay in place). Peel back about 300mm of the backing and cut it away.

STEP 5. Working from the bottom to the top, smooth the sticky section into place. Don't trim anything yet. Remove all of your tape.

STEP 6. Do not peel all the backing off in one go! Remove it slowly, smoothing down and side to side as you go.

STEP 7. Position Drop B using tapes in the same way as you did with Drop A. Use the faint line-up marks to guide you on the overlap.

STEP 8. Once B is in place, repeat the process, peeling away the top 300mm, sticking that section down and then slowly smoothing the rest of the drops in place.

STEP 9. Repeat the process. Place each drop in order (you will have overlaps all round).

STEP 10 a and b. Trim! Using a very sharp knlfe and your smoother to guide you, push into the corners and cut SLOWLY along the edges top, side and bottom.

STEP 10 a and b. Trim! Using a very sharp knlfe and your smoother to guide you, push into the corners and cut SLOWLY along the edges top, side and bottom.

STEP 11a. Next, splice your sections. Make a clean, straight, vertical cut through BOTH layers at the centre of the overlaps.

STEP 11b. Peel away the waste on the top layer.

STEP 11c. Lift the overlap and peel away the waste on the bottom layer. Smooth both layers back down.

STEP 12. All done!